Contact Us
  • 12 months warranty


PRESSLAM®1.1 is productive, easy-to-use, automatic hot mounting press, which will allow you to achive high production levels. The graphic interface guides you intuitively through the different settings. Via the machine's USB port it is also possible to transfer predefined hot mounting parameters. During the hot mounting cycle all phases are visible on the screen and can be modofied at any time. 4 pressurisation modes are available, along with a function reducing the amount of water used for cooling and each function can be adjusted separately.




Once put in service it runs a pre-heating cycle that is cleared after 6 minutes without intervention. When the safety cover is located in its intermediary position it is possible, after the mounting cycle, the expulsion of the sample.

The mounting chamber can be changed without any tools, nor electric or hydraulic connections. To change the complete heating unit, it takes a few minutes.




Technical Data

Capacity Ø25.4 to Ø50 mm
Heating system 4 x 600 W around mould
Temperature range 20 to 200°C
Heating cycle 0 to 30 mm
Cooling cycle 0 to 30 mm
Pressure 0 to 1.600 daN
Double mounting yes - all diameters
Program back-up 300 with USB connexion
Pressurisation modes 4 different modes
Chamber closing Half turned cover with a safety chamber
Mould changing Quick, without connectors - electric or hydraulic
Pre-heating mode Yes (cleared after 6 min without manipulation)
Water saving Yes (up to 25%)
Voltage 230 V - 50 Hz sinle-phase
Pneumatic feed 6 to 10 bars
Dimensions (W x H x D) 250 mm x 680 mm x 470 mm
Weight 72 kg (depending on mould size)
Reference 60 PL110 00